24/7 Vacations Web Search

  1. Ads

    related to: ubbink non condensing vent pipe cooling system

Search results

  1. Results from the 24/7 Vacations Content Network
  2. Condensing steam locomotive - Wikipedia

    en.wikipedia.org/wiki/Condensing_steam_locomotive

    A condensing steam locomotive is a type of locomotive designed to recover exhaust steam, either in order to improve range between taking on boiler water, or to reduce emission of steam inside enclosed spaces. The apparatus takes the exhaust steam that would normally be used to produce a draft for the firebox, and routes it through a heat ...

  3. Surface condenser - Wikipedia

    en.wikipedia.org/wiki/Surface_condenser

    A surface condenser is a water-cooled shell and tube heat exchanger installed to condense exhaust steam from a steam turbine in thermal power stations. [1] [2] [3] These condensers are heat exchangers which convert steam from its gaseous to its liquid state at a pressure below atmospheric pressure. Where cooling water is in short supply, an air ...

  4. Ground-coupled heat exchanger - Wikipedia

    en.wikipedia.org/wiki/Ground-coupled_heat_exchanger

    Ground-coupled heat exchanger. A qanat and windcatcher used as an earth duct, for both earth coupling and evaporative cooling. No fan is needed; the suction in the lee of the windtower draws the air up and out. A ground-coupled heat exchanger is an underground heat exchanger that can capture heat from and/or dissipate heat to the ground.

  5. Variable refrigerant flow - Wikipedia

    en.wikipedia.org/wiki/Variable_refrigerant_flow

    Variable refrigerant flow ( VRF ), also known as variable refrigerant volume ( VRV ), is an HVAC technology invented by Daikin Industries, Ltd. in 1982. [1] Similar to ductless mini-split systems, VRFs use refrigerant as the primary cooling and heating medium, and are usually less complex than conventional chiller -based systems.

  6. Heat pipe - Wikipedia

    en.wikipedia.org/wiki/Heat_pipe

    Heat pipe. A laptop computer heat pipe system. A heat pipe is a heat-transfer device that employs phase transition to transfer heat between two solid interfaces. [1] At the hot interface of a heat pipe, a volatile liquid in contact with a thermally conductive solid surface turns into a vapor by absorbing heat from that surface.

  7. Cooling tower - Wikipedia

    en.wikipedia.org/wiki/Cooling_tower

    A typical evaporative, forced draft open-loop cooling tower rejecting heat from the condenser water loop of an industrial chiller unit Natural draft wet cooling hyperboloid towers at Didcot Power Station (UK) Forced draft wet cooling towers (height: 34 meters) and natural draft wet cooling tower (height: 122 meters) in Westphalia, Germany Natural draft wet cooling tower in Dresden (Germany)

  8. Condenser (heat transfer) - Wikipedia

    en.wikipedia.org/wiki/Condenser_(heat_transfer)

    A condenser is designed to transfer heat from a working fluid (e.g. water in a steam power plant) to a secondary fluid or the surrounding air. The condenser relies on the efficient heat transfer that occurs during phase changes, in this case during the condensation of a vapor into a liquid. The vapor typically enters the condenser at a ...

  9. Chilled beam - Wikipedia

    en.wikipedia.org/wiki/Chilled_beam

    Chilled beam. A chilled beam is a type of radiation / convection HVAC system designed to heat and cool large buildings through the use of water. [1] This method removes most of the zone sensible local heat gains and allows the flow rate of pre-conditioned air from the air handling unit to be reduced, lowering by 60% to 80% the ducted design ...

  1. Ads

    related to: ubbink non condensing vent pipe cooling system